![]() ![]() The use of data packets also makes it extensible, meaning more features can be added over time without significant changes to the physical interface. Unlike legacy standards that transmit a clock signal with each output, its protocol is based on small data packets known as micro packets, which can embed the clock signal in the data stream, allowing higher resolution using fewer pins. It permits the use of internal and external display connections. It is the first display interface to rely on packetized data transmission, a form of digital communication found in technologies such as Ethernet, USB, and PCI Express. It is backward compatible with other interfaces, such as HDMI and DVI, through the use of either active or passive adapters. ĭisplayPort was designed to replace VGA, FPD-Link, and Digital Visual Interface (DVI). It can also carry audio, USB, and other forms of data. It is primarily used to connect a video source to a display device such as a computer monitor. ^ a b Pins 13 and 14 may either be directly connected to ground or connected to ground through a pulldown device.ĭisplayPort connector A DisplayPort port (top right) near an Ethernet port and a USB portĭisplayPort ( DP) is a digital display interface developed by a consortium of PC and chip manufacturers and standardized by the Video Electronics Standards Association (VESA).^ a b c d e f g h This is the pinout for source-side connector, the sink-side connector pinout will have lanes 0–3 reversed in order i.e., lane 3 will be on pin 1(n) and 3(p) while lane 0 will be on pin 10(n) and 12(p). ![]() and 30/20 pins for internal connections between graphics engines and built-in flat panels.ġ.62, 2.7, 5.4, 8.1, or 20 Gbit/s data rate per lane 1, 2, or 4 lanes (effective total 5.184, 8.64, 17.28, 25.92, or 77.37 Gbit/s for 4-lane link) 2 or 720 Mbit/s (effectively 1 or 576 Mbit/s) for the auxiliary channel. Optional, maximum resolution limited by available bandwidthĢ0 pins for external connectors on desktops, notebooks, graphics cards, monitors, etc. But exactly one monitor (either first or second one) was always showing the black screen.Ħ.Optional 1–8 channels, 16 or 24-bit linear PCM 32–192 kHz sampling rate maximum bitrate 36,864 kbit/s (4,608 kB/s) By changing settings/turning displays on and off I somehow managed to "move" the black screen to the first monitor, and the second one started working. I thought that it's maybe a bug in compositor, so I tried switching VTs, logging out, restarting GDM. ![]() Black screen moved to it, first monitor started working completely fine.Ĥ. Now the previously working monitor only shows the black screen too.ģ. xrandr and Gnome settings were showing both monitors too.Ģ. But I was able to move the cursor away from the working monitor. After dpms suspend, both monitors woke up, but one of them was showing black screen (but no "no signal" osd or anything like that). On Windows I frequently see notifications about "link failure" or something like that, but on Windows the driver/card always recovers successfully (so no other problems except the annoying notification).Īlso, more details, maybe it wasn't clear:ġ. ![]() DisplayPort is selected on both of them.Īlso, I've never seen similar problem on RX 580 with the same monitors, either on Linux or Windows. On both monitors there are no "Auto" input option. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |